Suzuki GRAND VITARA Owner's Manual page 975

2) Remove O/D planetary gear assembly (1).
2. O/D clutch cylinder
3) With O/D clutch assembly (2) installed to oil pump,
apply compressed air (400 – 800 kPa, 4 – 8 kg/cm
57 – 113 psi) to oil hole (3) in oil pump (1) and
measure stroke of clutch piston. If it is not within
standard range, replace cushion clutch plate or
clutch disc.
Standard stroke of clutch piston
1.74 – 2.44 mm (0.069 – 0.096 in.)
2
3
4) Remove retaining ring (1) and then remove brake
hub (2).
5) Remove retaining ring (1) cushion plate (2), clutch
plate (3) and clutch disc (4) in that order.
6) With clutch piston return spring compressed with
IYSQ01510121-01
2 ,
1. Snap ring
7) Install O/D clutch cylinder to oil pump (2). Apply
8) Remove piston inner O-ring and piston outer O-ring
1
I5JB0A510097-01
9) Remove retaining ring from O/D planetary gear and
1
2
I5JB0A510098-01
1
4
3
2
I5JB0A510099-01
Automatic Transmission/Transaxle:
special tools, remove clutch piston return spring.
Special tool
(A): 09918–48211
(B): 09926–98320
(C): 09918–48220
1
compression air into fluid hole (3) in oil pump (2) and
remove clutch piston (1).
from clutch piston (1).
3
then remove one-way clutch, thrust washer and
thrust bearing.
5A-107
(A)
(C)
(B)
I5JB0A510100-01
1
2
I5JB0A510101-01
IYSQ01510127-01