Illumination Cancel Switch (If Equipped) Inspection - Suzuki GRAND VITARA Owner's Manual

Grand vitara
Hide thumbs Also See for GRAND VITARA:
Table of Contents

Advertisement

9B-30 Lighting Systems:
Without initialization of the auto leveling headlight
system, it is not possible to obtain its proper function.
Also, if the auto leveling headlight system is not
initialized after replacing the headlight leveling control
module, the headlight leveling warning light in the
combination meter flashes.
1) Observe the following instructions.
Park vehicle on level ground.
• Adjust air pressure of all tires to the specified
value respectively.
• Bounce vehicle body up and down by hand to
stabilize suspension.
2) Turn ignition switch to ON position.
3) Perform "Headlight Leveling Warning Light Check: ".
4) Connect service wire (2) to terminals of diagnosis
connector (1).
5) Perform Steps a) through b) described blow within
20 seconds after Step 4).
a) Turn lighting switch (3) to "HEAD" position and
then turn lighting switch to OFF position.
b) Repeat Step a) 2 times.
1
2
6) Confirm that headlight leveling warning light flashes
3 times and turns off, which indicates that system
initialization was completed properly. If it does not
turn off after flashing 3 times, it means initialization
was not successful. In such case, turn off ignition
switch and perform Steps 1) to 6) again.
1
3
I5JB0A920032-01
I5JB0A920012-01
Illumination Cancel Switch (If Equipped)
Inspection
Check for continuity between terminals at each switch
position.
If check result is not as specified, replace switch.
1
2
3
4
Terminal
1
Switch Position
OFF
ON (PUSH IN)
S5JB0A9206021
3
2
4
I4RS0B920014-01

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents