Rear End Door Window Defogger Wire Inspection; Rear End Door Window Defogger Wire Repair; Power Window Main Switch Inspection - Suzuki GRAND VITARA Owner's Manual

Rear End Door Window Defogger Wire
Inspection
NOTE
• When cleaning rear end door window
glass, use a dry cloth to wipe it along heat
wire (1) direction.
• When cleaning glass, do not use detergent
or abrasive-containing glass cleaner.
• When measuring wire voltage, use a tester
with positive probe (2) wrapped with a tin
foil (3) which should be held down on wire
by finger pressure.
Wire Damage Inspection
1) Start engine.
2) Turn on defogger switch.
3) Measure voltage at the center of each defogger wire
(1), and check defogger wire condition according to
the following table.
If defogger wire open is found, go to next step.
Defogger wire voltage
Voltage
10 – 12 V Defogger wire open between its center
and defogger wire power source terminal
end (2)
4 – 6 V Normal condition
0 – 1 V Defogger wire open between its center
and defogger wire ground terminal end
(3)
2
S5JB0A9506014
I2RH01950002-01
Circuit
1
I5JB0A950033-01
Glass / Windows / Mirrors:
4) Touch voltmeter negative (–) lead to defogger wire
ground terminal end (1).
5) Touch voltmeter positive (+) lead with a foil strip to
defogger wire power source terminal end (2), then
move it along wire to defogger wire ground terminal
end (1).
The place where voltmeter fluctuates from 10 – 12 V
to 0 – 1 V is where there is open.
If found defective, repair defogger wire referring to

"Rear End Door Window Defogger Wire Repair: ".

2
Rear End Door Window Defogger Wire Repair
1) Use white gasoline for cleaning.
2) Apply masking tape (1) at both upper and lower
sides of heat wire (2) to be repaired.
3) Apply commercially-available repair agent (3) with a
fine-tip brush (4).
4) 2 to 3 minutes later, remove masking tapes (1).
5) Leave repaired heat wire as it is for at least 24 hours
before operating the defogger again.

Power Window Main Switch Inspection

Switch for driver side window
1) Remove driver side door trim referring to step 1) to
3) of "Front Door Glass Removal and Installation: ".
2) Remove power window main switch from door trim.
9E-20
1
I5JB0A950034-01
S5JB0A9506015
I2RH01950005-01
S5JB0A9506016