Dtc Clearance - Suzuki GRAND VITARA Owner's Manual

DTC Clearance

Using SUZUKI Scan Tool
1) Turn ignition switch to OFF position.
2) Connect SUZUKI scan tool to data link connector
(DLC) (1) in the same manner as when making this
connection for DTC check.
Special tool
(A): SUZUKI scan tool
(A)
3) Turn ignition switch to ON position.
4) Erase DTC according to instructions displayed on
SUZUKI scan tool. Refer to SUZUKI scan tool
operator's manual for further details.
5) After completing the clearance, perform "DTC
Check: " and confirm that normal DTC (NO CODES)
is displayed and not malfunction DTC.
6) Turn ignition switch to OFF position and disconnect
SUZUKI scan tool from DLC.
NOTE
If DTC B1013 or B1021 is stored in SDM, it is
not possible to clear DTC.
Using Monitor Connector (If Equipped)
S5JB0A8204005
1) Turn ignition switch to ON position and wait about 6
seconds or more.
2) Using service wire (4), repeat shorting and opening
between diagnosis switch terminal (3) on "AIR BAG"
monitor coupler (1) and body ground (2) 5 times at
about 1 second intervals within 10 seconds.
1
I5JB0A820013-01
3) Perform "DTC Check: " and confirm that normal DTC
(NO. 0000) is displayed and not malfunction DTC.
NOTE
If DTC B1013 or B1021 is stored in SDM, it is
not possible to clear all DTC.
Air Bag System:
1
2
3
T
O
1 2 3
S
T1 T1
O: Open
S: Short T1: About 1 sec.
8B-17
1
4
4 5
I5JB0A820016-01
T: Max, 10 seconds