Remote Audio Control Switch Inspection
1) Remove driver air bag (inflator) module referring to
"Driver Air Bag (Inflator) Module Removal and
Installation: in Section 8B".
2) Disconnect remote audio control switch connector
from contact coil.
3) Check switch for resistance between "a" and "b"
terminals under each condition below.
If check result is not satisfactory, replace remote
audio control switch.
"ENTER", "+" and "–" switch resistance
All switches released (OFF): 4700 – 5600 kΩ
"ENTER" switch (1) pushing on (ON): 50 – 60 Ω
"+" switch (2) pushing on (ON): 120 – 140 Ω
"–" switch (3) pushing on (ON): 220 – 260 Ω
4) Check switch for resistance between "a" and "b"
terminals under each condition below.
If check result is not satisfactory, replace remote
audio control switch.
Tightening Torque Specifications
Fastening part
Instrument panel mounting bolt
Lower anchor bolt
Antenna base mounting nut
NOTE
The specified tightening torque is also described in the following.
"Audio System Component Location: "
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fastener Information: in Section 0A".
"MODE",
S5JB0A9306026
All switches released (OFF): 4700 – 5600 kΩ
"MODE" switch (4) pushing on (ON): 370 – 460 Ω
Specifications
Tightening torque
N⋅m
kgf-m
23
35
10
Instrumentation / Driver Info. / Horn:
and
switch resistance
witch (5) pushing on (ON): 680 – 820 Ω
switch (6) pushing on (ON): 1400 – 1700 Ω
1
2
[A]
[B]
"a"
"b"
"a"
"b"
[A]: Without cruise control system
[B]: With cruise control system
lb-ft
2.3
17.0
3.5
25.5
1.0
7.5
9C-22
I5JB0A930028-01
S5JB0A9307001
Note