Axc (Axial Plunger Pump Coupling) (If Equipped) - Suzuki GA413 Manual

INSTALLATION
Install propeller shaft reversing removal procedure noting following
points:
D When installing propeller shaft, align the match marks.
Otherwise, vibration may occur during driving.
D Use following specification to torque each joint flange.
Tightening Torque
(a): 23 N
D Apply grease to spline part of propeller shaft and transmission
output shaft.
NOTE:
If transmission oil was drained for propeller shaft removal,
pour specified gear oil into transmission case to specified
level.
1. AXC (if equipped)
AXC (Axial Plunger Pump Coupling)
(if equipped)
REMOVAL
1) Hoist vehicle.
2) Before removing AXC, give match marks on each joint flange.
3) Remove AXC (1) by removing bolts and nuts fastening AXC.
2. Front differential
INSPECTION
Check AXC for rotation.
AXC can be rotated by hand but it is heavy.
If it can be rotated lightly by hand, or can not be rotated, replace
AXC.
1. AXC
INSTALLATION
Reverse removal procedure for installation.
Tightening Torque for AXC Bolts and Nuts
Bolts: 23 N
Nuts: 26 N
1. AXC
.
m (2.3 kg-m, 16.6 lb-ft)
.
m (2.3 kg-m, 16.5 lb-ft)
.
m (2.6 kg-m, 19.0 lb-ft)
PROPELLER SHAFT (4WD) 4B1-5