Rear End Door Glass Removal And Installation; Rear End Door Window Defogger Relay Inspection - Suzuki GRAND VITARA Owner's Manual

9E-19 Glass / Windows / Mirrors:

Rear End Door Glass Removal and Installation

Refer to "Windshield Removal and Installation: " as
removal and installation procedures are basically the
same. However, note the following.
• Observe the following precautions when applying
adhesive (1) along glass (2) edge.
• Adhesive (1) should be applied evenly especially in
height.
• Be careful not to damage primer (3).
• With the position of fastener (4) properly aligned,
install glass (2) on rear end door panel (5).
• Press glass against body quickly after adhesive (1) is
applied.
Adhesive amount specifications and position for
rear end door glass
Height "a": 14 mm (0.55 in.)
Width "b": 7 mm (0.28 in.)
Width "c": 16 mm (0.63 in.)
Position "d": 15 mm (0.59 in.) for glass upper and
bottom section
Position "e": 8 mm (0.31 in.)
1
2
4
2
1
3
b
"a"
"c"
"d"
1
1
3
b
"a"
"c"
"d"
S5JB0A9506011
"e"
1
1
3
"b"
"a"
5
"c"
1
2
"e"
1
3
"b"
"a"
"c"
"e"
1
4
3
"b"
"a"
"c"
1
I5JB0A950030-01
Rear End Door Window Defogger Relay
Inspection
1) Disconnect negative (–) cable from battery.
2) Remove rear end door window defogger relay
(included in integration relay) (1) from main fuse box
(2).
3) Check that there is no continuity between terminal
"a" and "b". If there is continuity, replace relay.
4) Check that there is continuity between terminals "a"
and "b" when a 12 V battery is connected to
terminals "a" and "c".
If malfunction is found, replace it with a new one.
"a"
"b"
"c"
"c"
"a"
"b"
S5JB0A9506013
1
I5JB0A950031-01
I5JB0A950032-02