Dtc B1017: Power Source Voltage Low - Suzuki GRAND VITARA Owner's Manual

DTC B1017: Power Source Voltage Low

Wiring Diagram
Refer to "DTC B1016: Power Source Voltage High: ".
CAUTION
!
Be sure to observe instructions under CAUTION in "Air Bag Diagnostic System Check Flow".
DTC Will Set when
The power source voltage is below specified value for specified time.
Flow Test Description
Step 1: Check if voltage on battery is within normal range.
Step 2: Check if voltage applied to SDM is within normal range.
Step 3: Check if voltage applied to "L04" connector is within normal range.
Step 4: Check if DTC B1017 still exists.
DTC Troubleshooting
Step
1 1) Measure voltage on battery.
Is voltage 11 V or more?
2 1) With ignition switch OFF, disconnect SDM connector.
2) Check proper connection to SDM at "G47-16" or "G46-
11" terminal.
3) If OK, turn ignition switch ON and then check voltage
between "G47-16" [A] or "G46-11" [B] terminal on SDM
connector and body ground.
Special tool
(A): 09932–76010
[A]
[B]
Is voltage 8 V or more?
Action
"G47-16"
(A)
"G46-11"
Yes
Go to Step 2.
Go to Step 4.
I5JB0A820023-01
Air Bag System: 8B-27
S5JB0A8204013
No
Check charging system
and repair as necessary
referring to "Generator
Test (Undercharged
Battery Check): in
Section 1J".
Go to Step 3.