Suzuki GRAND VITARA Owner's Manual page 674

3B-25 Differential: Rear
5) Disassembly rear drive left retainer in the same
manner at Step 4), if necessary.
6) Take out differential assembly (1), outer race and
shim all at once.
7) Pull out differential side bearing (1) using special
tools.
Special tool
(A): 09913–65135
(B): 09925–86010
(B)
8) Remove drive bevel gear (hypoid gear), differential
gears, differential pinions and pinion shaft as follows.
a) With aluminum plates (2) placed on vise first,
grip differential case with it and remove drive
bevel gear (hypoid gear) (3) by removing its bolts
(1).
1
1
I5JB0A321012-02
(A)
1
I5JB0A321013-02
3
2
I5JB0A321014-02
b) Remove pinion shafts (1), differential gears,
washers, differential pinions, spring washers,
thrust washers and pinion joint.
9) Remove drive bevel pinion (hypoid gear) assembly
as follows.
a) Hold joint flange with special tool and then
remove flange nut by using power wrench (4 –
10 magnification) (2).
Special tool
(A): 09922–66021
2
1. Socket wrench
b) Make mating marks (1) on drive bevel pinion and
companion flange.
CAUTION
!
Do not make mating mark on the coupling
surface of the flange.
c) Remove flange (2) from drive bevel pinion. Use
special tool if it is hard to remove.
Special tool
(A): 09913–65135
(B): 09925–88210
1
I5JB0A321015-02
(A)
1
I5JB0A321016-02