Suzuki GRAND VITARA Owner's Manual page 625

8) Loosen lower arm outer bolt (1).
9) Disconnect upper arm joint from rear suspension
knuckle (1) with puller (2) and remove rear
suspension knuckle.
NOTE
Do not remove upper arm joint nut (3) to
avoid the rear suspension knuckle fall off.
3
1
1
I5JB0A230071-01
2
I5JB0A230072-01
Installation
1) Connect upper arm joint (2) to rear suspension
knuckle (1).
2) Tighten new upper arm joint nut (3) to specified
torque.
CAUTION
!
Do not reuse removed upper arm joint nut.
Tightening torque
Upper arm joint nut (a): 55 N·m (5.5 kgf-m, 40.0
lb-ft)
2
1
3) Install lower arm to rear suspension knuckle and
then tighten lower arm outer bolt (1) temporarily by
hand.
CAUTION
!
If reuse lower arm outer bolt, apply engine oil
to thread, bearing and trunk surface.
Rear Suspension: 2C-29
3,(a)
I5JB0A230073-01
1
I5JB0A230071-01