Lighting Systems; Precautions For Discharge Headlight Service (If Equipped); Precautions In Diagnosing Troubles (Vehicle Equipped With Auto Leveling Headlight System) - Suzuki GRAND VITARA Owner's Manual

Lighting Systems

Precautions for Discharge Headlight Service (If Equipped)

WARNING
!
• Do not touch igniter or ballast when lighting switch is at "HEAD" position to avoid possible electric
shock.
• Do not measure voltage or resistance with tester connected to output connector of ballast or igniter
to avoid possible electric shock.
• Do not perform work where exposed to water including rain or with wet hands to avoid possible
electric shock.
• Disassembling igniter or ballast is strictly prohibited as it may cause an electric shock.
• Before inspecting or repairing discharge headlight or its peripheral parts, make sure that lighting
switch is at OFF position and battery is disconnected at negative terminal to avoid possible
electrical shock.
• Do not set lighting switch to "HEAD" position with connector disconnected or any part removed to
avoid possible electric shock.
• Do not touch glass surface of headlight bulb. Oil or grease attached on it may not only make bulb
service life shorter but also cause bulb to burst when lighting switch is turned on.
• Mercury, metal iodide and xenon gas are sealed in discharge headlight bulb. Be sure to dispose of
used discharge headlight bulb properly according to applicable rules or regulations.

Precautions in Diagnosing Troubles (Vehicle Equipped with Auto Leveling Headlight System)

• Be sure to read "Precautions for Electrical Circuit Service: in Section 00" before inspection and observe what is
written there.
• Replacement of height sensor and headlight leveling control module.When height sensor and/or headlight leveling
control module is replaced with new one, perform initialization of auto leveling headlight system according to
"Initialization of Auto Leveling Headlight System: ".
Precautions

Lighting Systems:

9B-1
S5JB0A9200001
S5JB0A9200002