• For automatic stop operation
a. Connect battery positive (+) terminal to
terminal "1" and its negative (–) terminal to
body ground and let the motor turn.
b. Connect terminal "2" and "3" by a jumper wire.
c. Observe the motor (4) turns once again then
stops at a specified position as shown.
1
3
5
4
5. Mark
d. Repeat Step a. to c. several times and check
that the motor stops at the specified position
every time.
If check result is not satisfied, replace motor.
Windshield Wiper and Washer Switch Removal
and Installation
Removal
2
I5JB0A940019-01
Installation
Reverse removal procedure.
1) Disconnect negative (–) cable at battery.
2) Remove steering column hole cover (1).
3) Remove steering column covers (2).
Turn steering wheel to access steering column cover
rear end screws (3).
2
1
4) Remove windshield wiper and washer switch (1)
from combination switch assembly (2) and
disconnect its coupler (3).
2
Wipers / Washers:
9D-10
S5JB0A9406008
3
3
I5JB0A940020-01
1
3
I4RS0B940008-01