Suzuki GRAND VITARA Owner's Manual page 607

e) The marks (5) on control rod washer (3) and rear
suspension frame marked before its removal
must be aligned and, tighten bolt and nut
temporarily by hand.
5
3
[A]
2 1
[A]: Correct
[B]: Wrong
2) Tighten parking cable hanger bolt (1) to specified
torque.
Tightening torque
Parking cable hanger bolt (a): 10 N·m (1.0 kgf-
m, 7.5 lb-ft)
1,(a)
U
[B]
L
4
3
I5JB0A230021-01
U: Upper side
L: Lower side
I5JB0A230022-01
3) Lower jack and remove floor jack (2) from lower arm
(1).
4) Install rear wheels and lower hoist.
5) Tighten wheel nuts to specified torque.
Tightening torque
Wheel nut: 100 N·m (10.0 kgf-m, 72.5 lb-ft)
6) Tighten control rod mount nut and control rod outer
bolt to specified torque with vehicle weight on
suspension.
CAUTION
!
• It is the most desirable to have vehicle off
hoist and in non-loaded condition when
tightening them.
• Tighten control rod washer with match
marks aligned.
Tightening torque
Control rod mount nut: 135 N·m (13.5 kgf-m,
98.0 lb-ft)
Control rod outer bolt: 135 N·m (13.5 kgf-m, 98.0
lb-ft)
7) Check rear toe and camber adjust it as necessary.
For check and adjustment procedures, refer to "Rear
Wheel Alignment Inspection and Adjustment: ".
Rear Suspension: 2C-11
1
2
I5JB0A230018-01