Desiccant Removal And Installation - Suzuki GRAND VITARA Owner's Manual

3) Remove front bumper assembly referring to "Front
Bumper Components: in Section 9K".
4) Remove front bumper upper member referring to
"Front Bumper Components: in Section 9K".
5) Disconnect compressor discharge hose (1) and
liquid pipe (2) from condenser assembly (4).
CAUTION
!
As soon as above hose and pipe are
disconnected, cap opened fittings so that
moisture and dust do not enter condenser.
6) Remove condenser assembly mounting bolts (3),
and then remove condenser assembly.
NOTE
Be careful not to damage fins of condenser
and radiator.
3
Installation
Reverse removal sequence to install condenser, noting
the following point.
• Replenish specified amount of compressor oil to
compressor suction side referring to "Precautions on
Replenishing Compressor Oil: ".
• Evacuate and charge the A/C system referring to
"Evacuation" and "Charge" in "Operation Procedure
for Charging A/C with Refrigerant: ".
3
1
2
4
I5JB0A720036-02
Air Conditioning System:

Desiccant Removal and Installation

Removal
1) Remove condenser assembly from vehicle referring
to "A/C Condenser Assembly Removal and
Installation: ".
2) Remove circlip (4) using special tool.
Special tool
: 09900–06107
3) Remove the filter (1) from the receiver / dryer tank
(2).
4) Remove desiccant (3).
3
1
Installation
Reverse removal sequence to install desiccant,
according to instruction manual with supply parts.
NOTE
• Replenish specified amount of compressor
oil to compressor suction side referring to
"Precautions on Replenishing Compressor
Oil: ".
• Install circlip (1) as shown in figure.
7B-64
S5JB0A7206007
2
4
I5JB0A720037-02
1
I5JB0A720038-01