Front Wheel Speed Sensor Inspection; Rear Wheel Speed Sensor On-Vehicle Inspection; Rear Wheel Speed Sensor Removal And Installation - Suzuki GRAND VITARA Owner's Manual

4E-36 ABS:

Front Wheel Speed Sensor Inspection

Check sensor for damage.
If any malcondition is found, replace.
Rear Wheel Speed Sensor On-Vehicle
Inspection
Refer to "Front Wheel Speed Sensor On-Vehicle
Inspection: " since rear wheel speed sensor is the same
as front wheel speed sensor.
Rear Wheel Speed Sensor Removal and
Installation
Removal
1) Disconnect negative cable from battery.
2) Disconnect rear wheel speed sensor coupler (1).
3) Hoist vehicle and remove wheel.
4) Remove harness clamp (4) and clamp bolts (2).
5) Remove rear wheel speed sensor (3) from knuckle.
CAUTION
!
• Do not pull wire harness when removing
rear wheel speed sensor.
• Do not cause damage to surface of rear
wheel speed sensor and do not allow dust,
etc. to enter its installation hole.
3
Installation
S5JB0A4506007 Reverse removal procedure for installation noting the
following.
• Check that no foreign material is attached to sensor
(1) and mating encoder (2).
• Be sure to install wheel speed sensor (1) and its bolt
at the correct (upper) position as shown in figure.
Tighten sensor bolt and harness clamp bolts to
specified torque.
Tightening torque
Rear wheel speed sensor bolt (a): 11 N·m (1.1 kgf-
I5JB0A450031-01
m, 8.0 lb-ft)
Rear wheel speed sensor harness clamp bolt
(b): 11 N·m (1.1 kgf-m, 8.0 lb-ft)
S5JB0A4506008
Do not pull or twist wire harness more than
necessary when installing rear wheel speed
sensor.
• Check that there is no clearance between sensor and
brake back plate.
S5JB0A4506009
4
1
2
I5JB0A450032-02
CAUTION
!
(a)
1
2
[A]
1
[A]: OK
(b)
[B]
1
I5JB0A450033-01
[B]: NG