Suzuki GRAND VITARA Owner's Manual page 675

2
1
2
d) Remove drive bevel pinion (1) with rear bearing,
shim and spacer from carrier.
If it is hard to remove, screw an used nut (2) into
drive bevel pinion and hammer (3) on that nut
with a plastic hammer but never directly on drive
bevel pinion.
1
e) Remove drive bevel pinion rear bearing (2) by
using bearing puller (3) and hydraulic press.
CAUTION
!
To avoid rear bearing from being damaged,
support it at flat side of bearing puller.
(B)
(A)
I5JB0A321017-02
3
2
I5JB0A321018-01
1. Drive bevel pinion
10) Remove oil seal (1) using special tool.
Special tool
(A): 09913–50121
11) Using a hammer and brass bar (1), drive out front
bearing outer race (2).
12) Drive out rear bearing outer race (1) in the same
manner as Step 11).
Differential: Rear 3B-26
I1JA01322006-01
(A)
1
I5JB0A321019-01
I5JB0A321020-01
I5JB0A321021-01