Rear Quarter Window Removal And Installation - Suzuki GRAND VITARA Owner's Manual

11) Check for water leakage by pouring water over
windshield through hose. If leakage is found, dry
windshield and fill leaky point with adhesive. If water
still leaks even after that, remove glass and start
installation procedure all over again.
NOTE
• Do not use high pressure water.
• Do not blow compressed air directly at
adhesive applied part when drying.
• Do not use infrared lamp or like for drying.
CAUTION
!
Upon completion of installation, note the
following.
• Sudden closing of door before adhesive is
completely set may cause glass to become
loose or to come off. Therefore, if door is
opened or closed before adhesive is
completely set, make sure to open all door
glasses and use proper care.
• If molding is not securely in place, hold it
down with a tape until adhesive is
completely set.
• Each adhesive has its own setting time.
• Be sure to refer to its maker's instruction,
check setting time of adhesive to be used
and observe precautions to be taken
before adhesive is set.
• Refrain from driving till adhesive is
completely set so as to ensure proper and
sufficient adhesion.

Rear Quarter Window Removal and Installation

Removal
1) Clean both inside and outside of glass and around it.
2) Using tape, cover body surface around glass to
prevent any damage.
3) If necessary, remove instrument panel. Refer to
"Instrument Panel Removal and Installation: in
Section 9C".
4) If necessary, remove quarter under trim, center pillar
inner upper trim, rear pillar trim and head lining.
Refer to "Head Lining Removal and Installation: in
Section 9H".
5) Drill hole with eyeleteer (1) through adhesive and let
piano string through it.
I2RH01950051-01
Glass / Windows / Mirrors:
S5JB0A9506023
I2RH01950040-01
9E-8