Programming Transmitter Code For Keyless Entry System (Vehicle Without Keyless Start System); Keyless Entry Receiver Removal And Installation - Suzuki GRAND VITARA Owner's Manual

9F-13 Security and Locks:
Programming Transmitter Code for Keyless
Entry System (Vehicle without Keyless Start
System)
NOTE
• Three transmitter codes can be registered.
• When a new transmitter code is registered,
the oldest one will be cleared.
• As for vehicle equipped with keyless start
system, perform "Registration Procedure
for Remote Controller ID Code: in Section
10E" instead of "Programming Transmitter
Code for Keyless Entry System (Vehicle
without Keyless Start System): ".
If transmitter or BCM is replaced with a new one or
additional transmitter(s) is necessary, program
transmitter code(s).
1) Confirm that all doors are closed and ignition key is
out of ignition key cylinder
2) Open driver side door.
3) Turn ignition switch to ON position, and then drawn
ignition key from ignition key cylinder within 10
seconds after that.
4) Push and release driver side door switch (1) at 3
times by hand within 20 seconds after removing
ignition key from ignition key cylinder.
5) Turn ignition switch to ON position, and then drawn
ignition key from ignition key cylinder within 10
seconds after that. All doors automatically lock and
unlock once.
With this, registration mode.
6) Push "UNLOCK" button (2) on transmitter (3) within
20 seconds after Step 5). All doors automatically lock
and unlock once.
With this, code registration is completed.
7) If an additional transmitter, needs to be programed
repeat the procedure of Step 1).
S5JB0A9606015
1
2
3
I4RS0B960010-01
Keyless Entry Receiver Removal and
Installation
Removal
1) Disconnect negative cable at battery.
2) Remove console box from vehicle body referring to
"Console Box Components: in Section 9H".
3) Disconnect keyless entry receiver coupler.
4) Remove keyless entry receiver (1).
1
Installation
Reverse removal procedure.
S5JB0A9606016
I5JB0A960020-01