Suzuki GRAND VITARA Owner's Manual page 622

2C-26 Rear Suspension:
3) Install rear wheel assembly and back plate to rear
suspension knuckle and tighten rear wheel hub
housing bolts (1) to specified torque.
Tightening torque
Rear wheel hub housing bolt (a): 50 N·m (5.0
kgf-m, 36.5 lb-ft)
1,(a)
4) Tighten parking cable cap nut (1) to specified torque.
Tightening torque
Parking cable cap nut (a): 11 N·m (1.1 kgf-m, 8.0
lb-ft)
5) Connect brake pipe (1) to wheel cylinder (2) and
tighten brake pipe flare nut (1) to specified torque
and install bleeder plug cap (3) taken off pipe back to
bleeder plug.
Tightening torque
Brake pipe flare nut (a): 16 N·m (1.6 kgf-m, 11.5
lb-ft)
1,(a)
3
2
1,(a)
I5JB0A230062-01
10) Upon completion of all jobs, depress brake pedal
1,(a)
I5JB0A230063-01
11) Install rear wheels.
12) Check to ensure that brake drum is free from
13) Lower hoist and tighten rear wheel bolts to specified
14) Perform brake test (foot brake and parking brake).
15) Check each installed part for fluid leakage.
I5JB0A230064-01
6) Install rear break shoe referring to "Rear Brake Shoe
Removal and Installation: in Section 4C".
7) Pull up parking brake lever fully and tighten new rear
axle nut (1) to specified torque.
Tightening torque
Rear axle nut (a): 200 N·m (20.0 kgf-m, 145.0 lb-
ft)
8) Caulk rear axle nut (1).
CAUTION
!
Be careful while calking nut so that no crack
will occur in calked part of nut. Cracked nut
must be replaced with new one.
9) Fill reservoir with brake fluid and bleed brake
system. Refer to "Air Bleeding of Brake System: in
Section 4A".
with about 30 kg (66 lbs) load three to five times so
as to obtain proper drum-to-shoe clearance. Adjust
parking brake cable. Refer to "Parking Brake Check
and Adjustment: in Section 4D".
dragging and proper braking is obtained.
torque.
Tightening torque
Wheel nut: 100 N·m (10.0 kgf-m, 72.5 lb-ft)
I5JB0A230065-01