Suzuki GRAND VITARA Owner's Manual page 1061

Installation
CAUTION
!
After tightening steering column assembly
mounting bolts and nuts, steering shaft joint
bolts should be tightened.
1) Be sure that front wheels and steering wheel are in
straight-ahead position.
2) Align flat part "A" of steering upper shaft upper joint
(1) with bolt hole "B" of steering column assembly (2)
as shown in the figure. Then connect steering upper
shaft upper joint.
"B"
2
3) Install steering column assembly (1) with contacting
upper side of lower bracket slits to mounting bolts.
Tighten steering column upper mounting nuts (3) first
and then lower mounting bolts (2) to specified
torque.
Tightening torque
Steering column assembly mounting bolt and
nut (a): 25 N·m (2.5 kgf-m, 18.0 lb-ft)
1
4) Install column support bracket. (if equipped)
5) Install new steering upper shaft upper joint bolt (2)
and nut (1). Tighten new steering upper shaft upper
joint nut (1) to specified torque.
NOTE
Do not reuse steering upper shaft upper joint
bolt and nut.
Be sure to use new bolt and nut when
installing.
1
"A"
I5JB0A620022-01
2, (a)
3, (a)
I5JB0A620023-01
Steering Wheel and Column:
Tightening torque
Steering upper shaft assembly upper joint nut
(a): 23 N·m (2.3 kgf-m, 17.0 lb-ft)
1, (a)
6) For A/T vehicle, connect shift (key) interlock cable
(1) to ignition switch with ignition switch turned at
ACC position.
And then turn ignition switch LOCK position.
7) Connect steering lock assembly connector.
8) Install contact coil cable assembly referring to
"Contact Coil Cable Assembly Removal and
Installation: ".
9) Install washer switch referring to "Windshield Wiper
and Washer Switch Removal and Installation: in
Section 9D".
10) Install lighting switch referring to "Headlight Switch
(in Lighting Switch) Removal and Installation: in
Section 9B".
11) Install immobilizer control module (ICM) referring to
"Immobilizer Control Module (ICM) Removal and
Installation: in Section 10C".
6B-9
2
2
1, (a)
I5JB0A620024-01
1
I5JB0A620019-01