Gear Shift Control Lever Rear Case Assembly Disassembly And Reassembly; Gear Shift Control Lever Rear Case Assembly Inspection; Gear Shift Lever Front Case Assembly Removal And Installation - Suzuki GRAND VITARA Owner's Manual

Installation
1) Install gear shift control lever rear case assembly
with its plate to transfer case referring to figure for
proper installing direction of control shaft joint bolt
(2). Tighten plate bolts (1) and control shaft joint nut
(3) to specified torque.
Tightening torque
Plate bolt (a): 23 N·m (2.3 kgf-m, 17.0 lb-ft)
Control shaft joint nut (b): 18 N·m (1.8 kgf-m,
13.0 lb-ft)
1, (a)
2
3, (b)
2) Remount transmission assembly to vehicle referring
to "Manual Transmission Assembly Dismounting and
Remounting: "
Gear Shift Control Lever Rear Case Assembly
Disassembly and Reassembly
Disassembly and reassembly component parts referring
to "Gear Shift Control Lever Rear Case Assembly
Components: ".
Gear Shift Control Lever Rear Case Assembly
Inspection
• Check that gear shift control shaft moves smoothly
without abnormal noise. If abnormality is found,
replace defective part.
• Check bush and boot for damage and deterioration. If
abnormality is found, replace defective part.
Gear Shift Lever Front Case Assembly Removal
and Installation
Removal
1) Dismount transmission assembly referring to
"Manual Transmission Assembly Dismounting and
Remounting: "
2) Remove gear shift lever front case assembly (1)
from transmission rear case.
Installation
NOTE
I5JB0A520008-02
• Install gear shift lever front case to
transmission rear case without using
sealant for functional check.
• Install shift control lever and check to
make sure that it shifts smoothly
according to shift pattern as shown in the
figure.
S5JB0A5206029
S5JB0A5206030
Manual Transmission/Transaxle: 5B-12
S5JB0A5206031
1
I5JB0A520009-02
I5JB0A520010-01