Suzuki GRAND VITARA Owner's Manual page 779

4) Tapping yoke with a hammer, completely remove
bearing race.
5) Take out bearing race on the other side in the same
way as in Step 3) and 4).
6) Push out bearing race on flange yoke side as
described in Step 2) and 3), and then, holding
bearing race in a vise (1), tap flange yoke and take
out race. (Refer to the figure.)
Remove bearing race on the opposite side in the
same way.
NOTE
• Take care not to lose rollers in spider
bearing race when removing it.
• Fit removed bearings temporarily in spider
so that they can be reinstalled in their
original positions.
I5JB0A340006-01
Assembly
NOTE
Make sure that rollers inside spider bearing
race are all in place.
CAUTION
!
In assembly, be sure to use new circlips,
spider (1) and bearings (2). Reuse of circlips,
spider (1) and bearings (2) once assembled is
prohibited.
IYSQ01340007-01
Propeller Shafts: 3D-4
IYSQ01340008-01
IYSQ01340010-01