Suzuki GRAND VITARA Owner's Manual page 998

5A-130 Automatic Transmission/Transaxle:
18) When clutch disc and plate have been replaced,
check height difference between forward clutch input
shaft and transmission case (1) by measuring as
shown in the figure.
NOTE
If measured value is less than standard
value, remove forward clutch assembly and
install it again.
Standard height difference between forward
clutch input shaft and transmission case
"a": About 2.0 mm (0.079 in.)
2. Forward clutch
19) Apply grease to thrust bearing (1) and bearing race
(2), and then install them to forward clutch input
shaft.
2
1
20) Install O/D case by aligning cutout in O/D case (1)
and that in transmission case.
NOTE
Use care not to drop thrust rear race installed
to O/D case.
2. Cutout in automatic transmission
1
"a"
2
I5JB0A510135-01
I5JB0A510136-01
1
2
I5JB0A510137-02
21) Apply grease to thrust washers (1) and install them
to O/D planetary gear (2) and planetary ring gear (3),
and then install O/D input shaft assembly to O/D
case.
NOTE
• Fit claws of thrust washer into holes
securely.
• Use care not to drop thrust washer
installed to O/D planetary gear.
22) When clutch disc or plate has been replaced, check
height difference between O/D case (1) and O/D
clutch cylinder (2) by measuring it as shown in the
figure.
NOTE
Measure at the highest point along inner
circumference of O/D clutch cylinder.
Standard height difference between O/D case
and O/D clutch cylinder
"a": About 3.5 mm (0.138 in.)
I5JB0A510138-01
I5JB0A510161-01