Suzuki GRAND VITARA Owner's Manual page 665

23) Upon completion of gear tooth contact check in Step
22), caulk flange nut (2) with caulking tool (1) and
hammer.
24) Install rear cover (1) to differential carrier (2).
Tightening torque
Rear cover bolt No.1 (a): 50 N·m (5.0 kgf-m, 36.5
lb-ft)
Rear cover bolt No.2 (b): 85 N·m (8.5 kgf-m, 61.5
lb-ft)
1
25) Assembly front drive shaft retainer as follows.
a) Install front drive shaft bearing (1) using special
tool, and then install snap ring.
Special tool
(A): 09913–75520
b) Apply grease to oil seal lip, and then install oil
seal (1) using special tools as shown in figure.
Distance between retainer surface and oil
seal
"a": 4.7 – 5.2 mm (0.185 – 0.205 in.)
"A": Grease 99000–25010 (SUZUKI Super
Grease A)
I1JA01322021-01
(a)
2
(b)
I5JB0A321042-01
(A)
1
I5JB0A321043-01
Special tool
(A): 09924–74510
(B): 09951–16090
26) Apply grease to oil seal lip, and then install oil seal
into differential side right retainer (1) as shown in
figure.
Distance between retainer surface and oil seal
"a": 0.65 – 1.65 mm (0.026 – 0.065 in.)
"A": Grease 99000–25010 (SUZUKI Super
Grease A)
Special tool
(A): 09913–75520
Differential: Front 3B-16
I5JB0A321044-01
I5JB0A321045-01