Suzuki GRAND VITARA Owner's Manual page 780

3D-5 Propeller Shafts:
1) Make sure to apply grease to spider bearing race.
"A": Grease 99000–25030 (SUZUKI Super
Grease C)
2) Insert bearing race into yoke, using press, until it is
flush with yoke face. When doing this, insert spider
into bearing race to prevent rollers in bearing race
from coming out.
3) Aligning match marks (1) and insert the other
bearing race on the opposite side into yoke, using
press until it is flush with yoke face.
Tightening Torque Specifications
Fastening part
Front propeller shaft flange bolt
Rear propeller shaft flange nut
NOTE
The specified tightening torque is also described in the following.
"Propeller Shaft Construction: "
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fastener Information: in Section 0A".
4) Insert bearing races on the flange yoke side in the
same way as described in Step 1) and 2).
5) Securely fit 4 circlips to shaft and flange yoke.
NOTE
• Make sure that each circlip is fitted in
groove securely.
6) After assembly, check to ensure that both shaft yoke
and flange yoke move smoothly.
Propeller Shaft Inspection
Inspect propeller shaft, universal joint and ball joint for
damage, and propeller shaft for runout.
If damage is found or shaft runout exceeds its limit,
IYSQ01340009-01
replace.
Propeller shaft runout
Limit: 0.8 mm (0.031 in.)
I5JB0A340007-01
Specifications
Tightening torque
N⋅m kgf-m
30 3.0
85 8.5
S5JB0A3406004
IYSQ01340013-01
S5JB0A3407001
Note
lb-ft
22.0
61.5