Suzuki GRAND VITARA Owner's Manual page 984

5A-116 Automatic Transmission/Transaxle:
3) Using special tool and hydraulic press (1), compress
direct clutch piston return spring (3) and remove
retaining return spring ring (2).
Special tool
(A): 09926–98310
CAUTION
!
Be careful when applying pressure, for
overpressure will cause plate section of
piston return spring to deform.
4) Remove direct clutch piston return spring.
5) Install direct clutch cylinder to center support.
Remove direct clutch piston by blowing air into the
second hole from the left as shown in the figure.
Also, remove direct clutch inner piston by blowing air
into hole at the extreme right. And then remove O-
rings from pistons.
Assembly
Assemble each component by reversing disassembly
procedure and noting the following points.
• Always use new O-ring and apply A/T fluid before
installation.
• Do not align opening in retaining ring (2) with lug of
direct clutch piston return spring at retainer.
Special tool
(A): 09926–98310
IYSQ01510158-01
1. Hydraulic press
• Use care so that direct clutch piston return spring will
not fall or tilt.
CAUTION
!
Be careful when applying pressure, for
overpressure will cause plate section of
piston return spring to deform.
• Do not match opening (1) in retaining back plate ring
with cutout (2) in direct clutch cylinder.
IYSQ01510159-01
• Install clutch backing plate with its grooved side (1)
facing the front.
[A]: Front
IYSQ01510160-01
IYSQ01510161-01
I5JB0A510115-01