Suzuki GRAND VITARA Owner's Manual page 778

3D-3 Propeller Shafts:
• Install propeller shaft aligning match marks.
Otherwise, vibration may occur during driving.
• Use the following specification to torque universal joint
flange nuts and bolts. For front propeller shaft flange
bolt (front differential side), apply thread lock cement
to thread part of bolts if reused.
"A": Thread lock cement 99000–32110 (Thread
Lock Cement Super 1322)
Tightening torque
Front propeller shaft flange bolt (a): 30 N·m (3.0
kgf-m, 22.0 lb-ft)
Rear propeller shaft flange nut (b): 85 N·m (8.5
kgf-m, 61.5 lb-ft)
[A]: Front propeller shaft
[B]: Rear propeller shaft
Propeller Shaft Disassembly and Assembly
CAUTION
!
Never disassemble each joint.
Performing this prohibited service will affect
its original performance.
Disassembly
1) Give match marks (1) on flange yoke and shaft as
shown in the figure.
2) Using snap ring plier (1), remove 2 circlips.
3) Using special tool, push spider bearing race out 3 –
I5JB0A340004-01
4 mm (0.12 – 0.16 in.) from shaft yoke race.
NOTE
Before pushing it out, apply penetrate
lubricant between bearing race (1) and yoke
race (2).
Special tool
(A): 09926-48010
Spider bearing race installing position (length
"a")
"a": 3 – 4 mm (0.12 – 0.16 in.)
S5JB0A3406005
I5JB0A340007-01
I5JB0A340005-02