Sdm Inspection - Suzuki GRAND VITARA Owner's Manual

Removal
1) Disconnect negative cable at battery.
2) Disable air bag system referring to "Disabling Air
Bag System: ".
3) Remove console rear panel referring to "Console
Box Components: in Section 9H".
4) Disconnect SDM connector (1) from SDM (2).
[A]
[B]
[A]: Without side-air bag and curtain-air bag
[B]: With side-air bag and curtain-air bag
5) Remove SDM (1) from vehicle.
Installation
1) Check that none of the following faulty conditions
exists.
• Bend, scratch, deformity in vehicle body where
SDM is mounted.
• Foreign matter or rust on mating surface of vehicle
body where SDM is mounted.
2) Install SDM (2) to vehicle.
CAUTION
!
Ensure that arrow on the SDM is pointing
toward the front of the vehicle.
2
1
1
2
I5JB0A820109-01
1
I5JB0A820073-01
3) Tighten SDM bolts (1) to specified torque.
Tightening torque
SDM bolt (a): 6 N·m (0.6 kgf-m, 4.5 lb-ft)
A
3
A: Vehicle forward
4) Connect SDM connector (1) to SDM (2) securely.
[A]
[B]
[A]: Without side-air bag and curtain-air bag
[B]: With side-air bag and curtain-air bag
5) Install console rear panel.
6) Enable air bag system referring to "Enabling Air Bag
System: ".
7) Connect negative cable at battery.

SDM Inspection

WARNING
!
During service procedures, be very careful
when handling a Sensing and Diagnostic
Module (SDM).
Be sure to read "Precautions on Service and
Diagnosis of Air Bag System: " before
starting to work and observe every
precaution during work. Neglecting them
may result in personal injury or inactivation
of the air bag system when necessary.
Air Bag System: 8B-99
1, (a)
2
I5JB0A820074-02
3. Ground for air bag system
2
1
1
2
I5JB0A820072-01
S5JB0A8206004