Suzuki GRAND VITARA Owner's Manual page 618

2C-22 Rear Suspension:
Installation
1) Remounting rear differential to rear suspension fame
referring to "Rear Differential Unit Components: Rear
in Section 3B".
2) Support rear suspension frame with rear differential
by using mission jack, and jack up it.
WARNING
!
When mounting rear suspension frame, be
sure to apply some supporting equipment
(such as mission jack) under it at well-
balanced position in the center section so as
to prevent from its drop.
3) Install rear suspension frame (3) to vehicle body and
tighten rear suspension frame mount bolts (1) with
washer (2) to specified torque.
CAUTION
!
If reuse suspension frame mount bolt, apply
engine oil to thread, bearing and trunk
surface.
Tightening torque
Rear suspension frame mount bolt (a): 135 N·m
(13.5 kgf-m, 98.0 lb-ft)
2
1,(a)
4) Connect rear height sensor connector (3) and rear
5) Tighten wheel sensor bolt (1) to specified torque and
6) Tighten parking cable clamp bolt (1) to specified
2
3
1,(a)
I5JB0A230051-02
7) Install upper arm referring to "Upper Arm Removal
8) Install rear suspension knuckle referring to "Rear
9) Install rear drive shaft referring to "Rear Drive Shaft
10) Install lower arm referring to "Lower Arm Removal
11) Install trailing rod referring to "Trailing Rod Removal
height sensor harness clamp (4) (if equipped) for left
side.
then connect ABS wheel sensor harness clamp (2)
(if equipped).
Tightening torque
Wheel sensor bolt (a): 11 N·m (1.1 kgf-m, 8.0 lb-
ft)
4
3
torque and then connect parking cable clamp (2).
Tightening torque
Parking cable clamp bolt (a): 25 N·m (2.5 kgf-m,
18.0 lb-ft)
2
and Installation: ".
Suspension knuckle Removal and Installation: ".
Assembly Removal and Installation: Rear in Section
3A".
and Installation: ".
and Installation: ".
2
1,(a)
4
4
I5JB0A230052-01
1,(a)
I5JB0A230053-01