Abs; Precautions; Precautions In Diagnosing Troubles; General Description - Suzuki GRAND VITARA Owner's Manual

ABS

Precautions in Diagnosing Troubles

To ensure that the trouble diagnosis is done accurately
and smoothly, observe the following and follow "ABS
Check: ".
• If the vehicles was operated in any of the following
ways, ABS warning lamp may light momentarily but
this does not indicate anything abnormal in ABS.
– The vehicle was driven with parking brake pulled.
– The vehicle was driven with brake dragging.
– The vehicle was stuck in mud, sand, etc.
– Wheel spin occurred while driving.
– Wheel(s) was rotated while the vehicle was jacked
up.
• Be sure to read "Precautions for Electrical Circuit
Service: in Section 00" before inspection and observe
what is written there.
• Be sure to use the trouble diagnosis procedure as
described in "ABS Check: ". Failure to follow it may
result in incorrect diagnosis. (Some other diagnosis
trouble code may be stored by mistake in the memory
of ABS control module during inspection.)
• When disconnecting ABS hydraulic unit / control
module connector (1), pull down lock lever (2) of
connector.

ABS Description

The ABS (Antilock Brake System) controls the fluid
pressure applied to the wheel cylinder of each brake
from the master cylinder so that each wheel is not locked
even when hard braking is applied.
This ABS has also the following function.
While braking is applied, but before ABS control
becomes effective, braking force is distributed between
the front and rear so as to prevent the rear wheels from
being locked too early for better stability of the vehicle.
The main component parts of this ABS include the
following parts in addition to those of the conventional
brake system.
• Wheel speed sensor which senses revolution speed
of each wheel and outputs its signal.
• ABS warning lamp which lights to inform abnormality
when system fails to operate properly.
• ABS hydraulic unit / control module assembly is
incorporated ABS control module, ABS hydraulic unit
(actuator assembly), solenoid valve power supply
driver (transistor), solenoid valve driver (transistor),
pump motor driver (transistor).

Precautions

When connecting, set the connector on ABS hydraulic
S5JB0A4500001 unit / control module assembly and pull up the lock
lever (2) until it locks.
[A]
Precautions in On-Vehicle Service
When connector is connected to ABS hydraulic unit /
control module assembly, do not disconnect connectors
of sensors with ignition switch ON. Otherwise, DTC will
be set in ABS control module.

General Description

– ABS control module which sends operation signal
S5JB0A4501001
to ABS hydraulic unit to control fluid pressure
applied to each wheel cylinder based on signal
from each wheel speed sensor so as to prevent
wheel from locking.
– ABS hydraulic unit which operates according to
signal from ABS control module to control fluid
pressure applied to wheel cylinder of each 4
wheels.
– Solenoid valve power supply driver (transistor)
which supplies power to solenoid valve in ABS
hydraulic unit.
– Solenoid valve driver (transistor) which controls
each solenoid valves in ABS hydraulic unit.
– Pump motor driver (transistor) which supplies
power to pump motor in ABS hydraulic unit.
1
2
C
[A]: Disconnect C: Pull down to disconnect
[B]: Connect D: Pull up to connect

ABS:

4E-1
[B]
D
I4RH01450001-01
S5JB0A4500002