Suzuki GRAND VITARA Owner's Manual page 752

3C-64 Transfer: Motor-Shift Type (Transfer with Shift Actuator)
11) Install low gear (3), center differential (4) and
reduction shift sleeve (1) to rear output shaft (2).
4
[A]
3
[A]: Rear case side
12) Select shim (1) as follows.
a) Install shim, washer (2) and used snap ring (3)
into rear output shaft (4).
b) Check clearance between shim and washer.
c) If clearance is out of specified value, select shim
from the following table so that clearance
become specified value.
Clearance between shim and washer
: 0.1 – 0.3 mm (0.004 – 0.012 in.)
Available shim thickness
0.4 mm (0.016 in.)
0.6 mm (0.024 in.)
0.8 mm (0.031 in.)
1.0 mm (0.039 in.)
1.2 mm (0.047 in.)
1.4 mm (0.055 in.)
2
1
2
4
I5JB0A331042-02
1.6 mm (0.063 in.)
1.8 mm (0.071 in.)
2.0 mm (0.079 in.)
2.2 mm (0.087 in.)
2.4 mm (0.098 in.)
4 3
1
I5JB0A331043-01
13) Remove used snap ring, and then install new snap
ring (2) and needle bearing (1) to rear output shaft
(3).
3
14) Install needle bearings (1) to center case (2) using
special tools as shown in figure.
Distance between case and needle bearing "a"
: 0 – 0.5 mm (0 – 0.008 in.)
Special tool
(A): 09913–76010
(B): 09925–98210
(B)
(A)
1
2
1
2
I5JB0A331044-02
"a"
I5JB0A331045-02