Front Disc Brake Caliper Removal And Installation - Suzuki GRAND VITARA Owner's Manual

4B-5 Front Brakes:
Front brake disc deflection
Limit: 0.1 mm (0.004 in.)
Slide Pin Bolt / Cylinder Slide Pin
Check slide pin (bolt) for smooth movement as shown in
the figure.
If it is found faulty, correct or replace. Apply rubber
grease to slide pin (bolt) outer surface. Rubber grease
should be the on whose viscosity is less affected by such
low temperature a –40 °C (–40 °F).
Dust Boot
Check boot for breakage, crack and damage. If
defective, replace.
Front Disc Brake Caliper Removal and
Installation
Removal
1) Hoist vehicle and remove front wheel.
2) Remove brake flexible hose mounting bolt (1) from
caliper (2). As this will allow fluid to flow out of hose
(3), have a container ready beforehand.
CAUTION
!
Be careful not to twist flexible hose while
loosening the bolt.
3) Remove caliper pin bolts (1).
4) Remove caliper (2).
IYSQ01420009-01
Installation
1) Apply rubber grease to slide pin, then install caliper
to caliper carrier.
IYSQ01420021-01
NOTE
Use rubber grease whose viscosity varies
very little even at –40 °C (–40 °F) if applied.
2) Tighten caliper pin bolts (1) to specifications.
NOTE
Make sure that boots are fit into groove
S5JB0A4206005
securely.
Tightening torque
Caliper pin bolt (a): 36 N·m (3.6 kgf-m, 26.0 lb-ft)
3
2
1
2
1,(a)
1
I5JB0A420006-01
I5JB0A420007-01
I5JB0A420008-01