Control Rod Removal And Installation - Suzuki GRAND VITARA Owner's Manual

2C-10 Rear Suspension:

Control Rod Removal and Installation

Removal
1) Hoist vehicle and remove rear wheels.
2) Support lower arm (1) with jack (2).
3) Remove parking cable hanger bolt (1).
1
4) Put match marks (1) on control rod washer (2) and
S5JB0A2306010 on suspension frame (3) to install the bolts correctly
in position.
5) Remove control rod inner bolt (4) and control rod
outer bolt (5) and then control rod (6).
1
2
Installation
I5JB0A230018-01
1) Install control rod (1).
a) Install control rod (1) to rear suspension frame.
b) Insert control rod inner bolt (2) from the vehicle
c) Install control rod washer (3) with its graduated
d) Insert control rod outer bolt (4).
CAUTION
!
If reuse control rod outer bolt, apply engine
oil to thread, bearing and trunk surface.
I5JB0A230019-01
4
6
3
1
frontward.
part facing up.
5
2
I5JB0A230020-01