Out Of Range Call Warning Notification; Figure 2-100 Out Of Range Example - NEC Univerge SV8100 Features And Specifications Manual

Hide thumbs Also See for Univerge SV8100:
Table of Contents

Advertisement

Issue 12.0
With SV8100 Version 5000 (5.00 or higher) software and PZ-IPLB daughter board
installed, half duplex connections are not supported. For troubleshooting purposes, a
managed switch capable of port mirroring is required to capture packet data from the
SV8100 IPLB Ethernet port.

Out of Range Call Warning Notification

Description
With Version 8000 software, it is possible to determine when a SIP-Dect terminal is Out of Range or
powered off. When an internal caller calls the Out of Range SIP terminal, either a lock out tone or call
forwarding can be performed. When the Out of Range timer (Program 24-02-15) expires, CFW is
performed when Program 24-09-01 is set to 2-5 and the dial is set to the suitable place of Program
24-09-02~24-09-05. If CFW is not set, the calling terminal hears a Lock-out tone and the following Out of
Range notice is displayed on the originators LCD.
Conditions
When a call comes into an idle SIP terminal which has not been recognized as out of range,
the system waits for the timer in Program24-02-15 (default 4 sec) to expire to determine if
the terminal is Out of Range state or not.
Out of Range transfer works against the SIP terminal in an Out of Range state when
Program 24-09-01 is set to a value between 2 and 5 (2: No Answer, 3: Immediate, 4: Busy/
No Answer or 5: Busy). In case of a value of 0 or 1 (0: None or 1: Both), Out of Range
transfer does not work.
When the SIP terminal starts ringing and then moves to out of range, the terminal keeps
ringing because the terminal is no longer under the control of the system. In this case the
Out of Range transfer is not applied.
Out of Range transfer is applied to individual calls only, group incoming calls or paging call
to a SIP terminal are not applied.
In case of Ring Transfer to the SIP terminal Out of Range transfer is not applied. It follows
No Answer timer in Program 24-02-03.
2 - 2046

Figure 2-100 Out of Range Example

UNIVERGE SV8100
Wireless DECT (SIP)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents