Chrysler 1998 Viper RT/10 Owner's Manual page 828

22 - 6 TIRES AND WHEELS S R
DIAGNOSIS AND TESTING {Continued)
ADJUST TIRE PRESSURE TO
P R E S S U R E S H O W N ON T I R E
PRESSURE PLACARD.
CHECK THE VEHICLE CURB
HEIGHT. IF NOT CORRECT REFER
TO GROUP 2 SUSPENSION FOR
SERVICE PROCEDURES.
ROADTEST
CAR LEADS WORSE
IN SAME DIRECTION
RETURN FRONT TIRES
TO ORIGINAL POSITION
I
OK
* C A R L E A D S
CROSS SWITCH FRONT
TIRE AND WHEEL ASSEMBLIES
ROAD TEST
CAR LEADS SAME DIRECTION
PROBABLE CAUSE-VEHICLE ALIGNMENT
RESET FRONT ALIGNMENTTO
PREFFERRED S P E C I F I C A T I O N ^
OK
CAR LEADS OPPOSITE DIRECTION
PROBABLE CAUSE-TIRES
INSTALL A KNOW GOOD SET OF FRONT
TIRE AND WHEEL ASSEMBLIES.
ROAD TEST - • O K ROAD TEST
CAR STILL LEADS
ADJUST FRONT CASTER
AND/OR CAMBER TO
COMPENSATE.
I
1
r
f
LEAD CORRECTED
CAR STILL LEADS
REPLACETHE
CONTACTTHE
FRONT TIRES. TIRE MANUFACTURE.
ROADTEST
• OK
CAR STILL LEADS
CONTACTTHE
TIRE MANUFACTURER
*NOTE: VERIFY THAT LEAD IS NOT RELATED TO STEERING WHEEL NOT CENTERED
[ T l S E E ALIGNMENT IN GROUP 2 (SUSPENSION) OF THIS SERVICE MANUAL FOR THE ALIGNMENT
SETTING PROCEDURE AND THE PREFERRED ALIGNMENT SPECIFICATIONS.
Vehicle Lead Correction Diagnosis Chart
8050056c