Chrysler 1998 Viper RT/10 Owner's Manual page 340

8K • 6 WINDSHIELD WIPERS AND WASHERS
SIRS
R E M O W A L A N D I N S T A L L A T I O N ( C o n t i n u e d )
CONTROL MODULE TO W I P E R / W A S H E R CONTROL SWITCH
C O N T R O L L E R
C O N N E C T O R
CONNECTOR CONTINUITY
13
12
3
7
6
19
, Y E S
Y E S
Y E S
Y E S
, Y E S
, Y E S
IF NO CONTINUITY, R E P A I R A S N E C E S S A R Y
WIRING H A R N E S S C O N N E C T O R
AT C O N T R O L M O D U L E
21 20 19 18 17 16 15 14 13 12 11
10 9 8 7 6
•
5 4 3 2 1
• B L A C K
9 [ • • • • • • • • • ] 1
17 fan • • ( ^ • • • • 1 1 0
M U L T I F U N C T I O N
S W I T C H
80a67700
Fig. 7 Continuity Test - Wiper/Washer Switch
S T R A P
Fig. 8 Control Module Location
INSTALLATION
For installation reverse above procedures. Tighten
attaching nuts to 3 N - m (26 i n . lbs.) torque.
WINDSHIELD WASHER RESERVOIR PUMP
REMOVAL
(1) Remove washer reservoir and pump assembly.
(2) Notice position of pump, t h e n using a 19 m m
(3/4 i n . ) socket through the l i q u i d filler opening,
loosen the pump filter a n d n u t .
(3) Disconnect the outside portion of the pump.
(4) Remove inner and outer portions of the pump.
INSTALLATION
For installation reverse the above procedures. F i r s t
i n s t a l l rubber grommet into place i n bottom of reser-
voir.
W A S H E R
R E S E R V O I R
W A S H E R F L U I D
H O S E
F E N D E R
W E L L
W I N D S H I E L D
W A S H E R
P U M P
80a67703
Fig. 9 Windshield Washer Reservoir
W A S H E R H O S E
I N L I N E C O N N E C T O R
F E N D E R
I N N E R
S P L A S H
S H I E L D
W A S H E R
H O S E
W I N D S H I E L D W A S H E R
R E S E R V O I R
80a67705
Fig. 10 windshield Washer Hoses
WIPER A l l
The wiper arms/blades overlap. The driver's a r m /
blade must be above the passenger arm/blade i n the
park position.
REMOVAL
(1) L i f t cover over the pivot n u t and remove n u t
(Fig. 11).
(2) Remove the a r m from the pivot by using a
rocking motion.