Chrysler 1998 Viper RT/10 Owner's Manual page 102

2 - 80
SUSPENSION
S R
R E M O V A L
AND INSTALLATION (Continued)
Fig. 71 Removing Brake Shoe Retaining Pin
(7) P u l l the brake pad r e t a i n i n g p i n out of the cal-
iper (Fig. 72), then remove the anti-rattle spring (Fig.
72) from the caliper. C h e c k c o n d i t i o n o f sleeves
a n d r e t a i n i n g p i n s , r e p l a c e i f r e t a i n i n g p i n s a r e
c o r r o d e d , o r sleeves a r e w o r n o r d a m a g e d .
Fig. 72 Retaining Pin And Anti-Rattle Spring
(8) Slide outboard brake shoe toward rear of vehi-
cle u n t i l the brake shoe clears the top of the caliper
(Fig. 73). Then, lift brake shoe up and out between
caliper and outboard side of b r a k i n g disc (Fig. 73).
Fig. 73 Remove / Install Outboard Brake Shoe
(9) Slide inboard brake shoe toward rear of vehicle
u n t i l the brake shoe clears the top of the caliper (Fig.
74). Then, lift brake shoe up and out between caliper
and inboard side of rotor (Fig. 74).
Fig. 74 Remove / Install Inboard Brake Shoe
(10) Remove the brake rotor from the rear hub/
bearing while sliding i t out from rear brake caliper
assembly.
(11) Remove the hub n u t (Fig. 75) m o u n t i n g the
hub/bearing to the yoke.
(12) Remove the washer (Fig. 76) from the hub/
bearing and yoke.
(13) Remove the 4 bolts (Fig. 77) attaching the
hub/bearing to the knuckle.
(14) The hub/bearing should separate from the
yoke and the knuckle by p u l l i n g on i t by hand. I f the
hub/bearing w i l l not separate from yoke and knuckle
by hand, use Puller, Special Tool CT-1003 (Fig. 78), to
remove the hub/bearing.
(15) Remove the hub/bearing from the knuckle.