Special Tools - Chrysler 1998 Viper RT/10 Owner's Manual

S
p
FUEL SYSTEM
14 - 39
R E M O V A L A N D I N S T A L L A T I O N
C o n t i n u e d )
REMOVAL
(1) D r a i n the cooling system. Refer to Group 7.
(2) Disconnect the electrical connector from the
engine coolant temperature sensor.
(3) Remove the sensor.
INSTALLATION
(1) I n s t a l l sensor. Tighten to 27 N - m (20 ft. lbs.)
torque.
(2) Connect electrical connector to sensor.
(3) F i l l cooling system. Refer to Group 7.
VEHICLE SPEED SENSOR
For Removal/Installation of speed senors refer to
Group 2 1 , Transaxle.
SPECIAL TOOLS
FUEL
Extractor C-4334
S P E C I F I C A T I O N S
VECI LABEL
I f anything differs between the specifications found
on the Vehicle Emission Control Information (VECI)
label and the following specifications, use specifica-
tions on V E C I label. The V E C I label is located i n the
engine compartment.
TORQUE
D E S C R I P T I O N
T O E Q U E
Accelerator Bracket Bolt . . . . . . 11 N-m (95 i n . lbs.)
Accelerator Pedal . 12 N - m (105 i n . lbs.)
A i r Cleaner Screws 2.2 N-m- (20 i n . lbs.)
Coolant Sensor . . . . . . . . . . . . . . 27 N - m (20 ft. lbs.)
Crankshaft Position Sensor Bolt . . . . . . . . . 23 N - m
(200 i n . lbs.)
Fuel Injector Clamp . . . . . . . . . . 11 N-m (95 i n . lbs.)
Fuel Pump Module Locknut . . . . 34 N-m (25 ft. lbs.)
Fuel Tank Strap Bolt . . . . 20 N-m (175 i n , lbs.)
IAC Motor-To-Throttle Body Bolts . . . . . . . . 11 N - m
(95 i n . lbs.)
M A P Sensor
3 N-m (26 i n . lbs.)
IAT Sensor 6 N-m (50 i n . lbs.)
Oxygen Sensor 27 N - m (20 ft. lbs.)
Powertrain Control Module Screws . . . . . . . . 4 N - m
(35 i n . lbs.)
Throttle Body M o u n t i n g Bolts . . 11 N - m (95 i n . lbs.)
Throttle Position Sensor Screws 2.2 N - m
(19 i n . lbs.)
Vehicle Speed Sensor Bolt . 2.2 N - m (19 i n . lbs.)
Pressure Gauge Assembly C-4799-B
Fuel Pressure Test Adapter 6539
Spanner Wrench 6856