Main Shaft - Chrysler 1998 Viper RT/10 Owner's Manual

21 - 1 4 TRANSMISSION
SR
DISASSEMBLY AND ASSEMBLY (Continued)
MAIN SHAFT
D u r i n g m a i n shaft disassembly i t is i m p o r t a n t not
to interchange any of the snap rings.
(1) Remove m a i n shaft O-ring (Fig. 45). This
O-ring is used to hold the m a i n shaft tapered bearing
i n place d u r i n g the manufacturing of this transmis-
sion.
B E A R I N G
FIRST G E A R
MAIN SHAFT
O - R I N G
9321-89
Fig. 45 Main Shaft O-Ring
(2) Remove rear m a i n shaft tapered bearing (Fig.
46).
MAIN SHAFT
B E A R I N G
FIRST G E A R
9321-90
Fig. 46 Main Shaft Bearing
(3) Remove 1st gear and bearing from shaft (Fig.
47).
(4) Remove 1-2 snap r i n g w i t h snap r i n g pliers
from m a i n shaft (Fig. 48).
(5) Remove 1-2 t h r u s t washer and blocker r i n g
assembly from m a i n shaft (Fig. 49).
M A I N SHAFT
FIRST G E A R
NEEDLE
B E A R I N G
9321-91
Fig. 47 1st Gear and Bearing
MAIN SHAFT
S Y N C H R O N I Z E R
HUB
S E C O N D
G E A R
S N A P R I N G
PLIERS
S N A P R I N G
9321-92
Fig. 48 1-2 Snap Ring
MAIN SHAFT
BLOCKER
R I N G
S E C O N D
G E A R
S Y N C H R O N I Z E R
HUB
9321-93
Fig. 49 1-2 Thrust Washer and Blocker Ring