Chrysler 1998 Viper RT/10 Owner's Manual page 865

S R
BODY 23 - 2 9
REMOVAL AND INSTALLATION (Continued)
Fig. 50 Quarter Trim Panel
(6) Install screws to hold quarter t r i m panel i n
place.
(7) Place bulkhead t r i m panel into position and
secure.
CARPET
REMOVAL
(1) Remove door sill t r i m panels.
(2) Remove seat cushions.
(3) Remove seats.
(4) Remove seat belt buckles.
(5) Remove bulkhead t r i m panel.
(6) Remove quarter t r i m panels.
(7) Remove center console.
(8) P u l l carpet from adhesive on bulkhead (Fig.
51).
(9) Separate carpet from vehicle.
I N S T A L L A T I O N
(1) Using a flat bladed scraper, remove old adhe-
sive from bulkhead, i f necessary.
(2) Paint bulkhead to avoid corrosion, i f necessary.
(3) Apply adhesive on bulkhead panel i n pattern
shown (Fig. 51).
(4) Position carpet i n vehicle.
(5) Push carpet to adhesive on bulkhead.
(6) I n s t a l l center console.
(7) I n s t a l l quarter t r i m panels.
(8) Install bulkhead t r i m panel.
(9) Install seat belt buckles.
(10) Install seats.
(11) I n s t a l l seat cushions.
(12) I n s t a l l door sill t r i m panels.
Fig. 51 Carpet
SPORT CAP PAD
REMOVAL
(1) Loosen bolts attaching sport cap pad to sport
cap (Fig. 52).
(2) Remove pad from sport cap.
Fig. 52 Sport Cap Pad