Chrysler 1998 Viper RT/10 Owner's Manual page 307

S R
INSTRUMENT PANEL/GAUGES 8E -1
INSTRUMENT PANEL/GAUGES
C O N T E N T S
page
GENERAL INFORMATION
INTRODUCTION 1
DESCRIPTION AND OPERATION
MESSAGE CENTER 2
SEAT BELT WARNING SYSTEM 2
DIAGNOSIS AND TESTING
BRAKE SYSTEM WARNING LAMP TEST 2
ENGINE OIL PRESSURE SENDING UNIT TEST . 3
ENGINE OIL PRESSURE SWITCH TEST 3
FUEL LEVEL SENSOR 3
GAUGE TEST 3
HEADLAMP SWITCH 5
LOW OIL PRESSURE WARNING LAMP TEST . . 5
MESSAGE CENTER TEST 5
PANEL DIMMER SWITCH
6
SENDING UNIT TEST
7
SPEEDOMETER/TACHOMETER TEST
7
page
TEMPERATURE WARNING LAMP TEST 7
REMOVAL AND INSTALLATION
ASH RECEIVER ASSEMBLY 7
CIGAR LIGHTER 7
GAUGE LAMPS 9
GAUGE(S) 8
HEADLAMP SWITCH 9
HEATER BLOWER MOTOR SWITCH 9
HEATER CONTROL 9
HEATER CONTROL LAMP 9
HEATER CONTROL SWITCH
INSTRUMENT PANEL
MESSAGE CENTER/LAMPS
PANEL DIMMER SWITCH
SPEEDOMETER/TACHOMETER . . . .
TEMPERATURE CONTROL SWITCH
VEHICLE SPEED SENSOR
G E N E R A L I N F O R M A T I O N
INTRODUCTION
The electronic gauges have analog displays.
The instrument panel gauges are magnetic type.
When the ignition switch is i n the O F F position each
gauge should rest at or below the low graduation
point.
The Instrument Panel has six gauges and a mes-
sage center (Fig. 1):
• 200 m.p.h. (322 km/h) speedometer and t r i p
odometer
• 7,000 R P M tachometer
• Coolant temperature gauge
• O i l gauge
• Fuel gauge
• Volt gauge
D R I V E R A I R B A G S E C U R I T Y
M O D U L E I N D I C A T O R L E D
P A S S E N G E R
A I R B A G
M O D U L E
A I R B A G C O N T R O L
M O D U L E L O C A T E D
B E H I N D B E Z E L
8 0 b 4 6 b a a
Fig. 1 instrument Panel