Jwac (Japanese Web-Based Access Control); Jwac Global Settings - D-Link DES-3528 User Manual

xStack DES-3528 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
Confirmation
User Name
VLAN Name

JWAC (Japanese Web-based Access Control)

The JWAC folder contains three windows: JWAC Global Settings, JWAC Port Settings, JWAC User Settings.

JWAC Global Settings

Use this window to enable and configure Japanese Web-based Access Control on the Switch. Please note that JWAC
and Web Authentication are mutually exclusive functions. That is, they cannot be enabled at the same time. To use
the JWAC feature, computer users need to pass through two stages of authentication. The first stage is to do the
authentication with the quarantine server and the second stage is the authentication with the Switch. For the second
stage, the authentication is similar to Web Authentication, except that there is no port VLAN membership change by
JWAC after a host passes authentication. The RADIUS server will share the server configuration defined by the
802.1X command set.
To view this window, click Security > JWAC > JWAC Global Settings
To set the Web Authentication for the Switch, complete the following fields:
Parameter
JWAC State
Virtual IP
have selected local as their web based authenticator.
Re-enter the password.
User-VLAN Mapping
Enter the user name of a guest authenticated through this process, to be mapped to a
previously configured VLAN with limited rights.
Enter the VLAN name of a previously configured VLAN to which successfully authenticated
web user will be mapped.
Figure 9- 47. JWAC Global Settings
Description
Use this drop-down menu to either enable or disable JWAC on the Switch.
JWAC Configuration
This parameter specifies the JWAC Virtual IP address that is used to accept authentication
requests from an unauthenticated host. Only requests sent to this IP will get a correct
response. NOTE: This IP does not respond to ARP requests or ICMP packets.
JWAC Settings
167