7.
8. (Fabric OS only) Enter a percentage for the buffer in the Buffer Size field.
9. Click the right arrow button to move the threshold to the Selected Thresholds table.
10. Repeat steps 5 through 9 for each measure that you want to add to the policy.
11. Click OK on the New Threshold Policy dialog box.
12. Click OK on the Set Threshold Policies dialog box.
13. Make the threshold changes by selecting one of the following options:
14. Click OK on the Confirm Threshold Changes dialog box.
Editing a threshold policy
To edit a threshold policy, complete the following steps.
1. Select Monitor > Performance > Configure Thresholds.
2. Select the threshold policy you want to edit in the Available Threshold Policies table.
3. Click Edit.
DCFM Enterprise User Manual
53-1001775-01
(Fabric OS only) Enter a percentage for the low boundary in the Low Boundary field.
When the counter value goes below the low boundary an event is raised.
Counters may fluctuate around the upper or lower boundary of a range threshold, and as a
result cause numerous events in a short period of time. To reduce the number of events,
configure a buffer (a range of values just below the upper boundary and just above the lower
boundary) in which a counter does not register an event if it returns to a "normal" value. An
event only registers if the counter returns to a "normal" value beyond the buffer.
If an error is detected, a message displays informing you to enter a valid value. Click OK to
close this message. Fix any errors and repeat step 9.
The threshold policy displays in the Available Threshold Policies table with an added icon (
To assign a threshold policy to a fabric or device, refer to
page 313.
The Confirm Threshold Changes dialog box displays.
•
To only add new thresholds, select the Keep currently set thresholds and only add new
thresholds check box.
•
To overwrite all existing thresholds on all fabrics and devices, select the Overwrite all
thresholds currently set on all switches check box.
The Set Threshold Policies dialog box displays.
The Edit Threshold Policy dialog box displays.
Editing a threshold policy
"Assigning a threshold policy"
11
).
on
311