Disable Icmp Address-Mask - Extreme Networks ExtremeWare Command Reference Manual

Hide thumbs Also See for ExtremeWare:

Table of Contents

IP Unicast Commands

disable icmp address-mask

disable icmp address-mask {vlan <vlan name>}

Disables the generation of an ICMP address-mask reply on one or all VLANs.

Syntax Description

Specifies a VLAN name.

Usage Guidelines

Disables the generation of an ICMP address-mask reply (type 18, code 0) when an ICMP address mask

request is received. The default setting is enabled. If a VLAN is not specified, the command applies to

all IP interfaces.

This command only affects the generation of certain ICMP packets. Filtering of ICMP packets usually

forwarded by the switch is controlled by the access-list commands.

The following command disables the generation of an ICMP address-mask reply on VLAN accounting:

disable icmp address-mask vlan accounting

This command was first available in ExtremeWare 6.1.

Platform Availability

This command is available on all platforms.

ExtremeWare Software 7.3.0 Command Reference Guide

Extremeware 7.3.0