Remote Connect Commands - Extreme Networks ExtremeWare Command Reference Manual

26

Remote Connect Commands

This chapter describes commands for the Remote Connect feature, which enables Altitude access points
(APs) to be linked to a Summit 300-48 switch for image and configuration download without requiring
a direct wired connection. The Remote Connect feature requires an Advanced Edge license.
Remote Connect is accomplished by way of virtual port assignments on the Summit 300-48 switch. In
addition to the 48 physical ports on the switch (1:1-1:48), the Summit 300-48 has 48 virtual ports
(virtual:1-virtual:48) that can be accessed over any physical port connection.
Parameters that are configurable on a physical wireless port are also configurable on all virtual ports.
The only exception is the
configured. On a virtual port, the IP address is not configurable, because a remote A300 assigned to a
virtual port is required to obtain an IP address from the DHCP Server.
Virtual port numbers can range from 1 to 48; however, a maximum of 24 virtual ports can be configured
at one time on a Summit 300-48 switch. Virtual ports are accommodated in the ExtremeWare CLI using
the following convention for the <port> variable, where n is the port number:
<port> value Description
1:n
n
virtual:n
ExtremeWare 7.7 Command Reference Guide
parameter. On a physical wireless port, the IP address is manually
ipaddress
Physical port, Summit 300-48, Alpine 3800 series
Physical port, Summit 300-24
Virtual port, Summit 300-48
Example
configure wireless ports 1:2
configure wireless port 2
configure wireless port virtual:2
2157