Abs Modulator-Control Unit Removal And Installation - Honda Civic 2002-2003 Service Manual

ABS Components
ABS Modulator-Control Unit Removal and Installation (cont'd)
3. Disconnectthe six brake lines.
4. Remove the two 8 mm nuts.
5. Remove the ABS modulator-control unit (CI.
Installation
1. Install the ABS modulator-control unit, then tighten the two 8 mm nuts.
2. Align the connecting surface olthe ABS control unit 31P connector.
3. Push in the lock of the ASS control unit 31 P connector until you hear
it
click into place, then connect the connector.
4. Connect the six brake lines.
5. Bleed the brake system, starting with the front wheels.
6. Connect the PGM Tester, and do the solenoid function test for each wheel.
7. Bleed the brake system again, starting with the front wheels.
8. Start the engine, and check that the ABS indicator and brake system indicator go off.
9. Disconnect the Honda PGM Tester. Test-drive the vehicle, and check that the ABS indicator and brake system
indicator do not come on.
19-58