Table of Contents
Advertisement
Modified in version 6.3.0.1 firmware.
show bgp ipv6 route-reflection
Use this command to display a summary of BGP route reflection. This
command deprecates and replaces the show ipv6 bgp route-reflection
command.
Syntax
show bgp ipv6 route-reflection
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
If a route reflector client is configured with an outbound route map, the
output warns that set statements in the route map are ignored when
reflecting routes to this client.
The following information is displayed.
Field
Cluster ID
Client-to-Client Reflection Displayed as Enabled when this router reflects routes
Clients
Description
The cluster ID used by this router. The value is tagged
as configured when the value is configured with the bgp
cluster-id command. When no cluster ID is configured,
the local router ID is shown and tagged as default.
received from its clients to its other clients. Disabled
otherwise.
A list of this router's internal peers which have been
configured as route reflector clients.
Layer 3 Routing Commands
1342
Advertisement
Table of Contents
