Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 734

JUNOSe 11.0.x Broadband Access Configuration Guide
NOTE: The HTTP local server must be configured and enabled in the virtual router
for the interface on which you use the ip http redirectUrl command. Otherwise, the
URL redirect operation will fail.
ip http same-host-limit
ip http server
ipv6 http
ipv6 http port
694
Service Definition Examples
Example
host1(config-if)#ip http redirectUrl http://ispsite.redirect.com
Use the no version to restore the default, which disables the HTTP redirect
feature.
See ip http redirectUrl
Use to specify the maximum number of connections that can exist between one
IP address and the HTTP local server.
Specify a number in the range 0–1000.
Example
host1(config)#ip http same-host-limit 20
Use the no version to restore the default number of allowed connections, 3.
See ip http same-host-limit
Use to enable the HTTP local server to listen for and process IPv4 exception
packets.
Example
host1(config)#ip http server
Use the no version to disable the HTTP local server.
See ip http server
Use to create the HTTP local server to listen and process for IPv6 exception
packets.
Example
host1(config)#ipv6 http
Use the no version to delete the HTTP local server.
See ipv6 http.