Specifying Qos Parameter Instances In A Service Definition - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

1.
2.
3.
qos-parameter

Specifying QoS Parameter Instances in a Service Definition

After you configure a QoS parameter instance for Service Manager, you can reference
it in a service definition. For example:
When you activate a service, Service Manager creates the parameter instance and
overwrites previous parameter instances. For example, activating the qosserviceone
service definition creates a profile containing two QoS parameter instances. Service
Manager creates the qosParameterName1 parameter instance with the value of
bandwidth1, and creates qosParameterName2 with a value of bandwidth2.
If you activate the service definition using qosserviceone(2000000,3000000), Service
Manager creates qosParameterName1 with a value of 2000000 and
qosParameterName2 instance with a value of 3000000.
Configure the QoS parameter definition described in JUNOSe Quality of Service
Configuration Guide, QoS Parameter Overview.
You must configure at least one controlled-interface type and one
subscriber-interface type. The range specified in the parameter definition controls
the available value of the parameter instance.
Configure the QoS profile.
host1(config)#profile video
Configure the QoS parameter instance command in the profile.
host1(config-profile)#qos-parameter videoBandwidth1 add 40000
Use to create a parameter instance command in a profile. When the service is
activated, the parameter instances are created for the subscriber interface.
Use the add keyword in Profile Configuration mode to add a value to an existing
parameter instance.
Use the initial-value keyword to create a new instance with the specified value.
Examples
host1(config)#profile video
host1(config-profile)#qos-parameter max-subscriber-bandwidth initial-value
15000
In Profile Configuration mode, the no version removes the QoS parameter
instance command in the profile.
See qos-parameter
<# qosserviceone(bandwidth1, bandwidth2) #>
profile <# profileName ; '\n' #>
qos-parameter <# qosParameterName1 ; ' ' ; bandwidth1 ; '\n' #>
qos-parameter <# qosParameterName2 ; ' ' ; bandwidth2 ; '\n' #>
<# endtmpl #>
Chapter 27: Configuring Service Manager
Referencing QoS Configurations in Service Definitions
647