Mlppp-Bundle-Name; Interface-Desc - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual
For e series broadband services routers - broadband access configuration
Hide thumbs
Also See for JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010:
- Configuration manual (712 pages)
Table of Contents
Advertisement
radius include dhcp-gi-address
[26-62] MLPPP-Bundle-Name
Use the following command to manage the MLPPP-Bundle-Name RADIUS attribute.
radius include mlppp-bundle-name
[26-63] Interface-Desc
Use the following command to manage the Interface-Desc RADIUS attribute.
radius include interface-description
radius include dhcp-gi-address
Use to include the DHCP-GI-Address attribute in Access-Request, Acct-Start, and
Acct-Stop messages.
You can control inclusion of the attribute by enabling or disabling this command.
See radius include
Example
host1(config)#radius include dhcp-gi-address acct-stop enable
Use the no version to restore the default, disable.
radius include mlppp-bundle-name
Use to include the MLPPP-Bundle-Name attribute in Access-Request, Acct-Start,
Interim-Acct, or Acct-Stop messages.
You can control inclusion of the MLPPP-Bundle-Name attribute by enabling or
disabling this command.
There is no explicit command to include the MLPPP-Bundle-Name attribute in
Interim-Acct messages; however, the attribute is automatically included in
Interim-Acct messages when the attribute is enabled for Acct-Stop messages.
See radius include
Example
host1(config)#radius include mlppp-bundle-name acct-start enable
Use the no version to restore the default, disable.
radius include interface-description
Chapter 3: Configuring RADIUS Attributes
CLI Commands Used to Modify RADIUS Attributes
223
Advertisement
Table of Contents
Troubleshooting
